jzjxc.cn

News

  • How to make a qualified twin screw screw?

    How to make a qualified twin screw screw?

    How to make a qualified twin screw screw    1. The twin screw should be able to sweep the entire inner surface of the screw closely to obtain good heat conduction, mixing effect and narrow residence time.    2. The radial gap between the screw and the barrel (barrel) should be less than 0.003 times ... read more

    Jul 13,2020 Industry News
  • Maintenance of twin screw extruder

    Maintenance of twin screw extruder

    Maintenance of twin screw extruder In order to ensure the safe and stable production of the twin-screw extruder and prolong its service life, the maintenance of the twin-screw extruder must be strengthened. The basic contents are as follows:    (1) Maintenance during equipment operation Entrainment ... read more

    Jul 07,2020 Industry News
  • Pay attention to these points when using double alloy screw barrels

    Pay attention to these points when using double alloy screw barrels

     The use of double alloy screw barrels should pay attention to these points:    1. The sundries in the plastic should be removed.    Generally speaking, the fresh plastic purchased from the original factory does not have any debris, but after transportation, weighing, drying, color mixing, especiall... read more

    Jun 30,2020 Industry News
  • The main factors that affect the quality of plasticizing screw

    The main factors that affect the quality of plasticizing screw

    The main factors affecting the quality of plasticization are: aspect ratio, compression ratio, back pressure, screw speed, barrel heating temperature, etc.    1. Aspect ratio: the ratio of the effective working length of the screw to the diameter of the screw.   A. If the length-to-diameter ratio is... read more

    Jun 23,2020 Industry News
  • How to use the screw of injection molding machine

    How to use the screw of injection molding machine

    1. Never start the machine when the barrel has not reached the preset temperature. Newly opened electric heating generally requires the temperature to reach the set value 30 minutes before operating the screw    2. If the shutdown is more than half an hour, it is best to close the blanking port and ... read more

    Jun 18,2020 Industry News